Just So Soft Base I10-1044

Applications

• Light to medium colored garments
• Cotton

Features

• Creamy body
• Extremely Soft hand
• Excellent printability
• No build-up

Just So Soft Base is an extremely soft base that was formulated to be mixed with “ready-to-use” inks or PCs to reduce build-up and to achieve a water-base feel with a plastisol ink.

Bleed Resistance: None Opacity: Low º º

Opacity: Low

Storage: Ideally 65 to 80 F. Keep out of direct sunlight.

Mesh: 110-300. The higher the mesh count, the softer the feel.

Stencil: Any direct emulsion or capillary film. Wet on Wet Printing: Can be printed wet-on-wet to increase production.

Wet on Wet Printing: Can be printed wet-on-wet to increase production.

How much to add to “ready-to-use” Inks: Up to 70%. For best results use AP inks.

Mixing PC: Up to 25% PC by weight can be added to base.

Modifications: N/A Squeegee Hardness & Angle:

Squeegee Hardness & Angle: Medium to hard at a 45 degree angle. The higher the squeegee pressure is, the softer the feel

Flashing: Not recommended.

Squeegee Blade: Sharp.

Fusion/Curing: 325 F/160 C for 1 to 1 ½ minutes. Oven temperature can be increased and dwell time º º decreased. For heat presses use 390 F/195 C for 8 seconds. 

Wash-up: Any plastisol cleaner.

Special Notes: PVC inks are thermoplastic compounds that require heat to fuse or cure. If ink rubs off on a white cloth or cracks, temperature and/or dwell time should be increased. Do not dry clean and always test on fabric to be printed. How much to add to “ready-to-use” Inks: Up to 70%. For best results use AP inks.